1. Plug the soldering iron into an electric outlet. Wait until it warms up (couple of minutes.
2. Align the loop on top of the minifig’s head in such a way that it has the most clearance. (You don’t want the soldering iron’s tip to touch and melt the plastic.
3. Carefully insert the heated tip into the loop on top of the minifig’s head.
4. Wait a couple of seconds as the soldering iron’s tip transfers the heat over to the pin in the minifig’s body.
5. The heat will gradually release the pin and you can easily pull it out. This should take no mare then 1-2 second. WARNING! If you don’t pull out the heating pin immediately, it will start melting the plastic, so don’t linger. Pull it out as soon as you feel the pin is being released. And you are done!
Users browsing this forum: No registered users and 6 guests